Movie Madness for Cardz 4 Galz # 223

Apr 18, 2024 | Cardz 4 Galz, Uncategorized | 0 comments

Welcome back to the bi-weekly Cardz 4 Galz challenge # 223. Our host, Debbie, picked Spring Movie Madness for the theme. When you finish here, please visit the challenge site to see what the rest of the very talented design team members created. Then, don’t forget to upload your creations to our gallery. We look forward to seeing your creations there!

Here’s my The Bee Movie card:

I really had to think outside of the box for this one, and it took a lot of thinking. Then, it hit me – The Bee Movie. If you’ve joined me from the link on the C4Galz blog, then you already know I am not the only one who thought of this idea. I didn’t know Pamela also created a card using this movie, but other than using the same suite of products, we have very different cards.

Measurements:

The Sweet Sorbet base measures 11 by 4-1/4 inches, scored at 5-1/2 inches.
The Pool Party layer measures 4-1/8 by 5-3/8 inches. I actually cropped the Pool Party thin banner from the center of this cardstock since no one will see it.
The DSP (designer series paper) measures 4 by 5-1/4 inches.
I trimmed a piece of coordinating DSP to 6 by 2-1/2 inches for the envelope flap.
I also punch a 1-inch circle from another pattern of the DSP for the envelope seal and ran it through my XYRON create-a-sticker for the envelope seal.
The white banner and sentiment pieces were cropped from white scraps using the Stylish Shapes dies.
The red DSP piece measures 5-1/4 by 1-7/8 inches.
The white cardstock for the inside measures 4 by 5-1/4 inches.
I used leftover pieces of white, Daffodil Delight, and Sweet Sorbet to stamp the bee pieces.

Assembly:

I adhered the layers of cardstock and DSP together using multipurpose liquid adhesive.
The sentiment comes from the Bee My Valentine and Good Feelings stamp sets. Initially, I masked off the pieces of the sentiments I would not be using. However, I found that it was easier to stamp the “bee” on white cardstock and then trim down the “HAPPY” part of the sentiment. I adhered it using multipurpose liquid glue.
After cropping the white and Pool Party banners, I cut the Pool Party one in half. Each end is adhered to the back of the white banner with liquid glue. Then, I added dimensionals to the back of the sentiment and adhered it to the red DSP.
I love that the punch for these adorable bees use heart shapes for the antenna and wings pieces. After adhering the pieces using liquid glue, I added dimensionals to the back of the bees and adhered them to the card.
I finished the front of the card using some of the 2022 – 2024 matte decorative dots.
Since this is basically an all-occasion card, I left the inside panel for the card blank until I figure out for what occasion I will be using it.
With that, I’d finished this coordinated card, envelope, and envelope seal set.